Search

Schlüter-BARIN-R  System pipes for BARIN gutter system

Schlüter-BARIN-R are system pipes made of coated aluminium that match our gutter system. All down pipes have a diameter of 60 mm and feature a connecting sleeve.

BARIN-R-SK is a standard zinc down pipe cap that covers the connection of Schlüter-BARIN system pipes with a diameter of 60 mm to the in-ground drainage system.

BARIN-R-AZ is a copper tee pipe that connects Schlüter-BARIN system pipes with a diameter of 60 mm with the existing down pipes (diameter 110 mm – DN 100) of the roof drainage system.


Product image BARIN-R 1©Schlüter-Systems KG
zoom_out_map search

General product information

What this product does

Schlüter-BARIN is a gutter system for balconies and terraces.

All necessary pre-fabricated parts such as attachment screws, internal and external corners, connectors, end pieces, outlets, down pipes and spouts can be ordered as system accessories for the Schlüter-BARIN gutter elements.

Schlüter-BARIN is attached to the corresponding balcony finishing profiles Schlüter-BARA-RKLT, -RTK -RTKE, -RTKEG or -RTP with screws. The elongated openings on the underside of the gutters allow for setting up a slope of up to 30 mm.

All Schlüter-BARIN system components are attached to the gutter with screw-mounted connectors.

How to install this product

  1. BARIN gutter elements are individually cut to size and attached to the BARA profile with the supplied screws. The elongated openings allow for setting up a slope as needed.
  2. Waterproof connections between two gutter elements can be created by attaching a connector over the centre of the abutting joint.
  3. The connectors have a rubber seal to ensure proper waterproofing of the joints.
  4. To create internal and external corners, the pre-fabricated corner pieces are attached to the BARA profile with the supplied screws. Two connectors are placed over the centre of the joint. This step is identical for 90° and 135° corners.
  5. To connect a drain pipe, the perforated outlet in a length of approx. 20 cm is attached to the BARA profile with the two clip on connectors. Two connectors are arranged over the centre of the seam.
  6. The end caps are held against the gutter from below and attached with a connector.
  7. Screws and elongated holes are concealed by snapping on a cover profile.
  8. The final step involves adhering the edge covers.

What this product is made from

Schlüter-BARIN gutter components, including covers, end caps, internal and external corners and connectors, are made of colour coated aluminium.

Additional prefabricated components for the Schlüter-BARIN gutter system such as down pipes, pipe clamps, elbows, tee pipes, spouts, drain flap and connecting sleeves are made of colour coated aluminium.

The coating of the aluminium gutter is colour-stable, as well as UV- and weather-resistant. Visible surfaces should be protected against abrasion.

How to look after this product

Schlüter-BARIN requires no special maintenance or care. The colour coated surface of the aluminium profile is colour-stable. Damage to surface can be restored with paint.

Downloads

DownloadSelection
Schlüter-BARIN | Product data sheet 10.1
Product data sheet - © Schlueter-Systems
PDF – 2.45 MB