Schlüter-ECK-KHK  Cove-shaped profile for retrofit installation

1. Adhere Schlüter-ECK-KHK to finished wall corners with the installation adhesive Schlüter-KERDI-FIX or an equivalent material. Apply a bead of adhesive to the back of the profile anchoring legs before pushing them onto the edge or corner of the wall covering so the lateral edges make solid contact. Remove any substances that may inhibit bonding, such as grease, prior to applying the installation adhesive.
2. Remove any excess adhesive that has squeezed out from underneath the profile anchoring legs with a suitable cleaning product.
3. Then remove the protective film.

Schlüter-ECK-KHK is available in the following materials:

• E = stainless steel
  • V2A, material no. 1.4301 = AISI 304

The visible surfaces of the profile are covered with a protective film.

Material properties and areas of application

The suitability of the proposed profile types must be verified based on the anticipated chemical, mechanical and/or other stresses.

ECK-KHK is made of roll formed V2A stainless steel (material no. 1.4301). It is particularly well suited for applications that, in addition to heavy mechanical stresses, require resistance to chemicals such as acidic or alkaline media and detergents. Even stainless steel is not resistant to all chemical stresses. Substances such as hydrochloric or hydrofluoric acid or certain chloride and brine concentrations may cause damage. In certain cases, this also applies to seawater pools. Special anticipated stresses should therefore be verified in advance.