1. Select Schlüter-QUADEC-AC according to tile thickness.
2. Apply tile adhesive to the area where the tile covering will end, using a notched trowel. If QUADEC-AC is to be installed in an exterior wall corner, complete the tiling of one wall, then apply tile adhesive in the corner area of the second wall.
3. Press the perforated anchoring leg of QUADEC-AC firmly into the adhesive and align it.
4. Trowel additional adhesive over the perforated anchoring leg to ensure full coverage and fill the profile chamber with tile adhesive.
5. Solidly embed adjacent tiles and adjust flush with the profile’s upper edge. Full coverage must be obtained between the tile and the profile’s anchoring leg.
6. The tile is set to the lateral joint spacer, which creates an evenly spaced joint of 1.5 mm. Fill the joint completely with grout.
7. Use suitable materials and tools for the sensitive surfaces to avoid scratches or other damage. Setting materials must be removed immediately, especially on aluminium.
8. Matching preformed inside and outside corner pieces are available.

Schlüter-QUADEC-AC is available in the following materials:

• AC = colour coated aluminium

Material properties and areas of application

In applications exposed to chemical or mechanical stresses, the profile’s suitability must be verified.

The information provided below is intended as a general guideline.

Schlüter-QUADEC-AC (colour coated aluminium): The aluminium is pre-treated (chrome-plated) and powder-coated with a polyurethane covering. The coating is colour-stable, as well as UV- and weather-resistant. Visible edges should be protected against abrasion.

Note: Due to different manufacturing processes, slight colour discrepancies between the profiles and the corners may occur.