Schlüter-FINEC-E  Finishing profile made of stainless steel

1. Select Schlüter-FINEC-E in accordance with the tile thickness.
2. Press the trapezoid perforated anchoring leg of the profile firmly into the adhesive and align it (in the case of adjoining plaster or render place the anchoring leg on a suitable adhesive area first).
3. Trowel additional tile adhesive over the trapezoid perforated anchoring leg to ensure full coverage.

Corner formation with FINEC-AE/-TS/-AC/-E:

The adjoining tiles in the area of the profile must be chamfered by 45°.
When creating 3 way external corners, always start by embedding the pre-fabricated parts of the corner set in the tile adhesive. The following work sequence must be observed:

1. left corner piece (1 trapezoid perforation),
2. right corner piece (2 trapezoid perforations),
3. lower corner piece (3 trapezoid perforations),
4. cut profiles to size and set them in place.

The profile is available in the following finishes:

• E = stainless steel V2A, material no. 1.4301 = AISI 304

Material properties and areas of application

Schlüter-FINEC is available in a wide variety of materials and finishes. In applications exposed to chemical or mechanical stresses, the profile’s suitability must be verified. The information provided below is intended as a general guideline.

Schlüter-FINEC-E is made of roll formed V2A stainless steel (material no. 1.4301). It is particularly well suited for applications that, in addition to heavy mechanical stresses, require resistance to chemicals such as acidic or alkaline media and detergents. Even stainless steel is not resistant to all chemical stresses. Substances such as hydrochloric or hydrofluoric acid or certain chloride and brine concentrations may cause damage. In certain cases, this also applies to seawater pools. Special anticipated stresses should therefore be verified in advance.