1. Select Schlüter-RONDEC-PRO according to tile thickness.
2. Apply tile adhesive to the area where the tile covering will end, using a notched trowel. If RONDEC-PRO is used at external wall corners, finish tiling one wall first; then apply tile adhesive to the corner area of the second wall.
3. Press the perforated anchoring leg of RONDEC-PRO firmly into the adhesive and align it.
4. Trowel additional adhesive over the perforated anchoring leg to ensure full coverage and fill the rounded cavity with tile adhesive.
5. Solidly embed adjacent tiles and adjust them flush with the profile’s upper edge. Full coverage must be obtained between the tile and the profile’s anchoring leg.
6. The tile is set to the lateral joint spacer, which creates an evenly spaced joint of 1.5 mm. In the case of stainless steel, brass and PRG profiles, a joint of approx. 1.5 mm is recommended. Completely fill the space between the tile and the profile with grout.
7. Use suitable materials and tools for the sensitive surfaces to avoid scratches or other damage. Setting materials must be removed immediately, especially on aluminium.
8. Matching preformed inside and outside corner pieces are available.

The profile is available in the following materials:

• PRO = coloured PVC

Material properties and areas of application

Schlüter-RONDEC is available in a wide variety of materials and finishes.

In applications exposed to chemical or mechanical stresses, the profile’s suitability must be verified. The information provided below is intended as a general guideline.

Schlüter-RONDEC-PRO (coloured PVC) is made of pre-coloured, rigid PVC which resists bending or scratching. The material is UV resistant, although it is not permanently colour stable in exterior applications. The profiles are not suited for corners or transitions subjected to heavy mechanical stresses, e.g. at step edges or floor transitions.

Note: Due to different manufacturing processes, slight colour discrepancies between the profiles and the corners may occur.