Schlüter-BARA-FAP  Balcony edge profile with drip lip

1. Place the horizontal leg of the product flush on the concrete slab.
2. Depending on the properties of the exposed perimeters, it can be adhered with the adhesive Schlüter-KERDI-FIX or attached mechanically.
   Note:
   Substrates on which the profile is to be installed need to be evaluated for their stability. Prior to the use of KERDI-FIX, all components of the surface that may weaken the bond must be removed. If that is not an option, use anchors and screws for additional mechanical attachment.
   If screw attachment is necessary, position the screws in the top area of the profile. They can then be covered with an edge profile of the Schlüter-BARA product family.

Note: Abut the profile ends of BARA-FAP with a joint of approx. 5 mm and conceal the joint with the joint covering Schlüter-BARA-STU. To avoid vibrations in the screw-attached option, additional adhesion is recommended in the lower section.

The profile is available in the following material version:

• AC = colour coated aluminium

Material properties and areas of application

The profile is made of colour-coated aluminium. The coating of the aluminium profile is colour-stable as well as UV- and weather-resistant.

Visible surfaces should be protected against abrasion. In special cases, the suitability of the profile must be verified based on the anticipated chemical and mechanical stresses.